Vendor:    Kantronics
Bulletin:  KA4560
Subject:   HF tuning hint for KPC-3

I've used the following to put my KPC-3 pretty close to on frequency
to monitor HF packet.

     - Set HBAUD to 300
     - Set CD to INTERNAL
     - Set volume just past the point where a packet signal
       lights RCV
     - Set CD to SOFTWARE
     - Now RCV will light when data is being received even
       if only part of a packet is heard.  RCV will wink
       as you tune through a packet signal.  Set the tuning
       midway between the turn-on and turn-off points.  Stay
       there and you should be able to monitor the next complete
       packet heard.
     - Of course, this is a compromise since the KPC-3 is set to
       1000 Hz shift but it works for me.
     - THIS DOES NOT GIVE YOU THE 200 Hz SHIFT YOU NEED TO TRANSMIT
       ON FREQUENCIES BELOW 28 MHz AND STILL BE A GOOD "NEIGHBOR".