PACKET MADE EASY 02 The object of these bulletins are to familiarize newcomers and veterans of packet to the end user part of packet without complicating it with the more technical aspects of packet. SENDING BULLETINS In Packet Made Easy 01 we went over listing and reading messages and bulletins. Now that you are familiar with this you may want to sent a bulletin of your own. Keep in mind that any thing sent over packet MUST NOT VIOLATE PART 97 of the FCC rules. Keeping this in mind you are ready to start. One points to consider is will your message be of interest to others. If it isn't of interest to anyone there is no since in sending it into the packet system. To send a bulletin you should use a text editor or word processing program this will help in saving air time at the local level. Now that we have all this out of the way, let move on to the mechanics of sending a bulletin. To enter a bulletin you will use the command SB, and address it something like SB ALL @ USA or maybe SB BEACON @ USA. The word BEACON in the second example will give a hint of what is to come. Now that you have entered the address line you will want to enter the subject line (example 10 Meter Beacon List). Next you will want to send the text of your bulletin, ending it with a CONTROL Z. EXAMPLE: SB Beacon @ USA (ENTER) 10 Meter Beacon (ENTER) TEXT OF MESSAGE (transfer from word processor) ONE VERY IMPORTANT POINT TO REMEMBER *** KEEP YOUR MESSAGE BETWEEN 2000 TO 3000 BYTES *** EVEN IF YOU HAVE TO SEND IT IN TWO PARTS. You may be operating at 2400 or 1200 buad but keep in mind that your message will be going on HF at 300 buad. A message more that more than 3000 bytes may cause a bottleneck at a HF station. At best it will slow all traffic down and will probably be killed at that point. Packet Made Easy 03 will be on sending messages via the packet BBS system. 73 Stanley KC4DPC @ N4CCK.#ILMNC.NC.USA.NA