Kantronics Equipment Modifications List

Equipment Menu Home Page 

KAM Determining unknown signal baud rate

Erratic operation check voltage problem

-5 volt problem

HF performance improvement

DCD Carrier Detect operation on HF

CR/LF problems in the Amtor Mode

AM & FM switch modification

Audio modification for Kenwood TR78XX series

Keying a Uniden HR-2600 in the CW Mode

Hum problem on HF transmit

Installing the TAPR DCD state machine upgrade

Installing the Data Engine to the KAM

Problem using WEFAX

Abnormal long delays between retrys

Connecting the KAN for a Commodore C64/128

Correct transmit keying problems using the Yaesu FT-730

Feedback problems with the Kenwood TS-850S

Improving performance to the KAM+

Eliminate carrier interference on two meters

File changes needed using WinPack software

KPC-1 -5 volt problem & faulty filter capacitors

Connecting the KPC-1 to a Commodore C64/128

KPC-2 Erratic operation because of voltage problem

-5 volt problem with faulty capacitor

Installing the Data Engine to the KPC-2

Abnormal long delay between retrys

Connecting the KPC-2 to a Commodore C64/128

KPC-3 Installing internal NICAD battery

Installing additional memory and where to find it

TNC settings for 'KISS' Mode using G8BPQ software

Operating on HF, software changes

Internal clock and memory upgrade done cheaply

Eliminate carrier interference on two meters

KPC-4 Erratic operation because of voltage problem

-5 volt problem & faulty filter capacitors

Filter capacitors installed backwards

Installing the Data Engine to the KPC-4

Connecting the KPC-4 to a Commodore C64/128

KPC-2400 Erratic operation / voltage problems

Connection the KPC-2400 to the Commodore C64/128

KPC-9612 Hooking KPC-9612 to Motorola MITREK

 

HOME PAGE    TOP OF PAGE